Glass has become an indispensable material in our society, and the applications of glass are very extensive. Often produced as different types of Copper Free Mirror. The size of glass is very large in the production of glass. If it needs to be processed into small size glass, how is the glass cut? Next, let's take a look at how the glass is cut! 1. To prepare the work area, a large flat table is required. It is best not to be too hard to scratch the glass. If everything is not good, it is easy to be cut into an unsightly Color Mirror. The work area should be easy to clean. It is best to avoid working on carpet due to the potential for glass shards. 2. Clean the surface of the glass to be cut. Any stains and irregularities on the glass will prevent scratches on it. Wipe off the scratches with a rag or your fingers. 3. Prepare a glass cutter and some low-viscosity oil. The size of the glass cutter is similar to that of a pencil. Use a diamond or a hard grinding wheel to scratch the glass, so that the glass can be divided along the scratch. You can buy cutting oil at the hardware store or use some kerosene. 4. And mark the place to be scratched, the scratch must be from one side edge to the other side edge. You can use a marker to mark the glass (or a ruler if you're cutting straight lines). You can also use paper to mark, and then spread the paper under the glass. 5. The length should not be too long. Scratches exceeding 60 cm will increase the risk of glass breaking. 6. Leave an edge of about 15 cm on both sides of the scratch line to leave room for gripping. If you cut a small piece of glass, you may need special tools, such as pliers or a small hammer, to knock off the glass that cannot be grasped by hand. Glass. 7. Immerse the knife in the oil and hold it like a pencil. The oil-soaked glass cutter can draw smooth lines. Make sure to check that the wheel is aligned in the desired position and orientation. 8. For calibration, you can use a yardstick or a commonly used office ruler. Make sure that the ruler is thick enough to prevent conflict with the grinding wheel on the cutting knife. Press the glass with your hands, and use a glass cutter to roll and draw lines along the surface. Pay attention to the sound. The rustling sound means that you are using too much force or your glass cutter is not enough oil. The smaller the sound, the better the effect of marking the better. The above content explains how the glass is cut, and I hope it will be helpful to everyone.
